You can easily transform a furniture piece cheaply by stripping off the old paint and refinishing the wood as to its original state. By stripping old furnishings to the natural wood you can guarantee a smooth surface – free of bumps and acnes – which can be polished, varnished and even stenciled for a completely new look. Ensure first that you understand what finishes you are stripping because, paint, polish, lacquer or varnish all require different treatments.
Equipment: By hand, you require paint stripper, liquid or jelly form, methylated spirits, and turpentine. A pair of rubber gloves, old paintbrush 25 – 50 mm broad, a scraper, coarse wire wool and sandpaper fine to medium grade.
Paint Stripping: if you are professional for hard work it can be gotten rid of by immersing the article in a caustic bath. A more secure recommendation I would advise by hand, using a chemical paint stripper; this provides excellent outcomes as it includes an extra radiance to the bare wood.
Method: Firstly make certain that your workspace is well aerated as paint stripper produces unpleasant fumes. Get rid of all fittings handles, essential guides, etc, then start brushing the stripper on to the painted locations, work the stripper into all cracks/crevices. When you have actually covered a workable area, leave the stripper to act for several minutes. When it starts to bubble, remove the paint layer with your stripping knife or scraper, (put the paint shreds into an old paint tin as being caustic they threaten) repeat the procedure until you reach the wood. When all the paint has actually been stripped, next step is to wash the wood down with the makes recommendation on what neutralizer to utilize this will remove any remaining debris at the same time reduces the effects of the stripper. If the suggested neutralizer is state turpentine then soak a ball of wire wool and thoroughly rub-down the removed surface area. When dry sandpaper to a smooth finish. Essential; constantly rub in the direction of the grain.
Stripping polish: before you can eliminate effectively, you should know first of all the kind of polish. If it is French polish this can be eliminated rather easily with methylated spirits, wipe it on generously, leave for a few minutes. When the polish has softened, scrape it off with a scraper then with great wire wool (soaked in Methylated spirits) when the wood is dry you can sandpaper down to a nice smooth finish. If it is a Wax polish (oily surface area) this you can remove with great steel wool soaked with turpentine. Repeat till you are at the bare wood, dry off with an absorbent fabric.
Varnished and Lacquered surfaces: if the article being 50 years or more old it most likely is an oil-based varnish of which was made from resins liquified in oils and solvents. The cleanest/easiest method is with a scraper; tilt the scraper far from you working along the grain (never ever throughout the grain). Polyurethane varnishes use a paint stripper. Cellulose-based varnishes can be removed by paint stripper, acetone, cellulose slimmers, ammonia caustic soda, or turpentine. Suggest test a small area initially to see which works best. Repairs, now you have the ability to see the various faults. Your repair work is required before the brand-new finish can be applied, perhaps the draws need re-nailing or weak joints to be glued, fractures and holes should be filled. Minor fractures and holes you utilize a plastic wood or non-shrinking stopper all offered in numerous natural wood colors. Large holes should be Plugged with a comparable wood, cut to form making sure the grain of the pug runs the same way as the remainder of the surface area, and then glue it in. Fine sandpaper all your repairs down to a smooth finish for the next phase. Check more about tozsuz sistre cila.